The Paket 50 has two LEDs: and Blue (Network/GSM) . During normal operation:
| Frequency | Action | |-----------|--------| | Daily | Remove debris from sealing bar with cleaning brush (when cool). | | Weekly | Wipe label applicator roller with isopropyl alcohol. | | Monthly | Check film and label roll tension; clean internal fans with compressed air. | | Every 5000 cycles | Replace sealing bar Teflon tape (WeDo spare part #WDP-T50). | wedo paket 50 user manual
| Problem | Possible Cause | Solution | |---------|----------------|----------| | Won’t power on | Loose cable or blown fuse | Check outlet, replace fuse (5A, 250V) | | Poor seal / open packets | Temp too low or dirty sealing bar | Increase temp by 10°C; clean bar | | Label misaligned | Label offset setting wrong | MENU → Label offset: adjust +/- 2 mm | | Packet jams | Speed too high or guides too loose | Reduce speed; tighten side guides | | Red error light | Overheating or motor stall | Let cool 15 min; remove jam, restart | The Paket 50 has two LEDs: and Blue (Network/GSM)