V2000-c Rfid Access Control User Manual Exclusive Jun 2026

The V2000-C RFID access control system is a compact, 2,000-user device praised for stable performance, though users often find its programming manual complex. It supports multiple entry modes, including card-only, PIN-only, or card-and-PIN combinations. Detailed information and user experiences with the device can be found on JustAnswer .

The V2000-C RFID Access Control is a standalone 125KHz EM card system supporting up to 1,000 users, offering adjustable door open times, and featuring a rugged plastic, non-waterproof design. While praised for its fast response time and versatility, users often report complex programming procedures. For official setup instructions, you can download the V2000-C User Manual directly from Obohands. programming NTIL V2000-c+ RFID Access Keypad - JustAnswer

The V2000-C RFID Access Control is a standalone, single-door system supporting card-only, PIN-only, and card+PIN authentication modes with up to 2,000 user capacity. Key features include a Wiegand 26 interface, Tamper alarms, adjustable door delay, and compatibility with 125KHz EM cards. For more detailed technical specifications, visit goldbridgesz.com www.goldbridgesz.com

V2000-C RFID Access Control — User Manual Overview The V2000-C is an RFID access control reader and controller designed for single-door access management. It supports card/tag reading, basic user management, event logging, and integration with electric locks and exit devices. V2000-c Rfid Access Control User Manual

Safety & Precautions

Power: Use a regulated 12–24 V DC supply as specified by the device. Reverse polarity may damage the unit. Environment: Install indoors or in a weatherproof enclosure if outdoors. Operating temperature typically -20°C to 60°C; verify device label. Wiring: De-energize power before wiring. Separate low-voltage data wiring from high-voltage mains. Locks: Use appropriate fail-safe/fail-secure lock type depending on fire code and safety requirements.

What’s in the Box

V2000-C RFID reader/controller Mounting screws and anchors Quick start guide Warranty card

Hardware Description

Reader face with LED indicator Internal tamper switch (if equipped) Terminal block for power, lock output, door sensor, request-to-exit (REX), Wiegand or RS485 (if supported) Programming buttons (menu/confirm/cancel) or DIP switches for basic config Optional keypad (model-dependent) The V2000-C RFID access control system is a

Wiring Connections (typical)

V+ : 12–24 V DC positive GND : Power ground NO/NC/COM : Relay contacts for lock output (connect electric lock between COM and NO for powered-on unlock) D0 / D1 : Wiegand data lines (if acting as a reader-only device) TX / RX : RS485/TTL serial (if supported) Door Sensor : Door position input (NC/NO depending on sensor) REX : Request-to-exit button input Tamper : Tamper switch (connect to alarm panel if required)